Details of Sunny galvo laser head:Charry

Details of Sunny galvo laser head

Details of Sunny galvo laser head

We had a USA customer want to do rings continuous engraving,they want to find a suitable galvo head.

Details of Sunny galvo laser head

Firstly,Aperture size – could be 10mm, 12mm, 16mm, 20mm – What would be the best Aperture for engraving rings?

10mm scanhead is okay. By the way, what’s their laser soure, it should be fiber laser, if it is, certainly will equip with 10mm scanhead normally.
Secondly,Scan angle  12.5 or 20 – Would 12.5 be good for engraving rings?
 +/- 12.5  Mec. angle is standard for engraving.
Thirdly,Writing speed – 800, 680, 350, 300 – Would slower speed be better for ring engraving?
Speed depends on request, all Sunny 10mm scanhead can reach the speed requirement of engraving rings.
Some other questions:
Which model of Sunny head would you recommend for jewelry and ring engraving?
– S-9320A/D
– S-9210A/D
– TSH8310A/D
– TSH8720A/D
– S-9650A/D
 S9210A is enough for rings engraving.
And there are 2 different scanning technologies used for ring engraving:
1. Handshaking method – One segment at a time – The laser machine will engrave part on the graphics while the rotary stays on one place, when it is done it will rotate the ring on a new angle and engrave the second portion and so on… Usually the laser beam goes LEFT-RIGHT. It is good for engraving text but NOT for continuous graphics around the circumference of the ring.
2. Continuous engraving – The laser will engrave while the rotary is rotating the ring. The laser beam will go UP-DOWN.

Yes,we also can do this effect,we have made it before with you.

It need to plus one control board from JCZ to control the rotary motor,that means in the control cabinet,there will be two board, its no problem.
If you want to know more about the machine details,contact us:
Email:xintian111@xtlaser.com
Whatsapp:+8618253165863

Contacta con nosotros