It is important to control the fiber laser cutting machine speed – Catherine

It is important to control the fiber laser cutting machine speed

You may have such a misunderstanding that the speed of fiber laser cutting machine should be faster and better. So that we can do more work and create greater economic benefits. In fact, the fiber laser cutting machine cutting too fast will also have a lot of problems. It is important to control the fiber laser cutting machine speed. Control fiber laser cutting machine speed

fiber laser cutting machine
fiber laser cutting machine

The cutting speed of fiber laser cutting machine is too fast. It will cause incapability of cutting, sparking and sparing. Then there will be oblique stripe on the cutting surface. And the lower part will melt. Then the whole section will be thick. And no single melted stain will affect the accuracy and quality of the cutting plate. Therefore, we should control the fiber laser cutting machine cutting speed, XT LASER will give few suggestions.

1. The lathe and turning center of the fiber laser cutting machine can used at least three.

The feed and fast feed of X and Z axis are fast and smooth. The high precision and low backlash planetary gear reducer. And the precision ball screw screw used to reduce the mechanical failure rate and improve the precision. And the level of file servo control conversion device to shorten the time, rapid and smooth conversion.

2. The digital grinder and discharge machine of the fiber laser cutting machine can use at least three or more

The three axes of X, Y and Z are smooth and smooth, which make the parameters of the controller more simple. And it can make the finished product get high precision. Smooth the arc contact and reduce the surface roughness.

3. The machining center of the optical fiber laser cutting machine and the CNC milling machine can use at least four or more

X, Y axis feed and fast feed can increase feed smoothness, reduce noise and reduce servomotor cost. As the torque is high, the control is easier, although the load is different. And it does not affect the smooth feed. The above is a few suggestions.

Contacta con nosotros