Fiber laser cutting machine bed
Fiber laser cutting machine bed.
Comparison between the cast iron machine bed and thick metal plate machine bed.
For cast iron machine bed just need 7 days or 10 days to finish it,they just need to melt the iron and pour it into the mold,then its over,without any technology processing.
Our machine bed need 25 days to 30 days to finish one,there are many technology steps need to do.
If you produce one thing,time cost is the important cost too.
And the most important thing is that,the iron cast machine bed is melt into the mold.So there will be air bubble inside the bed,the machine bed is easy to split.And once the spliting,then the whole machine can not be used,because the iron cast is melted into a whole bed.
So if you have a checking of the machine bed,you can find that,90% suppliers use the thick plate machine bed,whatever the HAN’S,or XTLASER,even a smaller factory.
Cause we use the thick plate welding machine,we have removed the internal stress of the metal after the welding of the machine bed.Cause the machine bed has been on high temperature annealing.(because some suppliers use the CNC machine bed,do not with this step,the machine bed will be not stable for the fiber laser cutting)
This kind of machine bed has strongly reasonable structure, it is produced by relief annealing. So the whole structure is very firm and hard to be deformed.