Which type of air compressor should equip with fiber laser cutting machine – Catherine

Which type of air compressor should equip with fiber laser cutting machine

As we all know, laser cutting machines use auxiliary gases in processing products. The common gases of fiber laser cutting machines are air, oxygen and nitrogen. Among these three gases. And the lowest cost of air is the most customers’ choice. Air compressor fiber laser cutting machine

Which type of air compressor should eqip with fiber laser cutting machine? Today we will talk about which kind of air compressor is suitable for laser cutting machine.

fiber laser cutting machine manufacturer
Air condition fiber laser cutting machine

Fiber laser cutting machine industry commonly used air compressor can divide into air compressor oil and oil free air compressor two.

We often say that the oil free air compressor is not a little oil without oil, but the quantity is very little. So the laser cutting machine operation is stable. If the air compressor oil. Don’t say to cause a lot of waste lubricating oil, the laser cutting machine operation is extremely unfavorable. And it is easy to cause the laser cutting machine protective lenses or dirty water substances. So that the laser cutting machine of optical deviation or in the cutting process sometimes must not wear etc.. So which is the laser cutting machine?

XT LASER generally suggest that customers buy screw type oil-free air compressor, power is 7.5KW. The best pressure up to 9 kg (but also to achieve a minimum of 8 kg). The exhaust volume greater than 0.6 per minute. If the customer has bought the best oil air compressor with two oil filter, so as to reduce some water and dirty.

The fiber laser cutting machine needs to meet the cutting requirements of various materials and complex shapes.

But it does not operate without a clean, dry, stable compressed air. The compressed air is partly made up of high pure oxygen and high purity nitrogen to provide cutting gas to the cutting head. A part is supplied to the cylinder of the clamping table as a power source, and the last part is used to blow and dust the optical path system.

From the air discharged from the compressed air through the dryer into the gas tank and gas control cabinet, through a sophisticated processing system, a gas clean and dry. And finally into the three road, use as cutting gas cylinder. Power source and light road dust gas pressure to maintain the normal operation of laser cutting machine.

Contacta con nosotros