The details of fiber laser cutter: Charry

The details of fiber laser cutter

The details of fiber laser cutter.

The details of fiber laser cutter

XTLASER use the thick metal plate welding machine bed.(we use 12mm and 15mm thickness,some smaller companies only use 8mm.)

Maybe you know,Bodor use iron cast machine bed,so pls check as below:
Comparison between the cast iron machine bed and thick metal plate machine bed:

For cast iron machine bed just need 7days or 10days to finish it,they just need to melt the iron and pour it into the mold,then its over,without any technology processing.
Our machine bed need 25days to 30days to finish one,there are many technology steps need to do.
If you produce one thing,time cost is the important cost too.

Following with our machine bed processing:

15-18mm Thick plates cutting  — Welding

(Heat Process) High Temperature failure — Release the pressure of internal under over 650℃ environment.

Rough Manching — Removing the welding slag, milling out the shape of machine bed, making the processing surface for finish maching

Finish maching— 9 meters milling machine, ensure the reference for installation of rails, racks etc., positioning holes, installation holes etc.

Detectiong— Detecting the maching accuracy, parallelism, straightness etc., by adding meters on the milling machine

Blasting treatment— Removing the oxide layer/rust etc. on the machine bed

Paint spaying

Adding serial numbers— Each machine bed has its own serial No.

And he most important thing is that,the iron cast machine bed is melt into the mold,so there will be air bubble inside the bed,the machine bed is easy to split,and once the spliting,then the whole machine can not be used,because the iron cast is melted into a whole bed.

Finally,if you need more details about our fiber laser cutting machine.

Contact us:

Email:xintian111@xtlaser.com

Whatsapp:+8618253165863

XTLASER always here.

Contacta con nosotros